Model UCS-01
4
INSTALLATION
The Scheduler-Timer is designed for indoor use. Simply plug the appropriate
end of the power cord or L-shaped connector into the top of the UCS, and the
other end into any 120-volt outlet. For convenience the L-shaped power
connector is designed to hang the unit from a high (mid-wall) receptacle, typically
found in the kitchen or garage. The 6 foot power cord can be used when
programming as a hand-held device, or when mounting the unit in some other
location (e.g. table top).
When the memory battery back-up of the Scheduler-Timer is fully charged
(24 hours of powered / charging time required to achieve a full charge) the device
can be unplugged or un-powered for up to one week without losing time or
events. This feature also makes programming and testing of room lighting easy
since the user can power and program the unit in one location, then unplug the
device to move it to another ‘plug-in’ location within the house without losing the
time or programmed events. The UCS requires 120VAC power to operate.
When power is provided to the
Scheduler-Timer the unit runs a
start-up routine, and then shows the
‘Idle Screen’ on the display.
Idle Screen showing: time, Schedule
‘RUN’ Mode, date and day of the
week.
The diagnostic LED should be lit with an AMBER color
indicating the Scheduler-Timer is ready for use.
Controller, Scheduler-Timer
9
The following table details the Schedule Mode and Event Mode operation.
Schedule Mode is displayed on the Idle Screen and adjusted from the Set Time
screen. Event Mode is displayed and adjusted in the specific Set Event screen.
Schedule Mode:
(as viewed on
Idle Screen)
Event Mode:
Off
mode = ‘r’
Event Mode:
Run
mode = ‘R’
Event Mode:
Vacation mode
= ‘V’
[OFF] Off Off Off
[RUN] Off Run Off
[VAC] Off Run Run with vacation
randomness
• Set On Time / Off Time:
o The Up / Down buttons scroll through the hours:minutes, AM /
PM and deviations from Dusk and Dawn selections.
o Examples:
07:00P 11:00P, where the event or Link turns on at
7PM and turns off at 11PM.
Dusk+15 Dawn-30, where the event or Link turns on
at Dusk plus 15 minutes and turns off at Dawn minus
30 minutes.
------ 11:00P, where the event or Link (only) turns off
at 11PM. This function is used to make sure one or
more devices are turned off at a specific time (e.g. all
off command). Conversely, an event could be set to
only turn ON by entering an ON time and then
entering “------“ for the off time.
o A = AM, P = PM.
• Set Event Type:
o The Up / Down buttons scroll through the dim levels D0
through D9, and LA for Link Activator.
Dim levels: D0 = 100%, D9 = 90%, D8 = 80%... D1 =
10%.
LA is Link Activator, where the device(s) receiving the
Link control how they respond for dim Level and Rate.
• Press ENTER
button to save Event
• Once the event is saved, press ENTER
button to test Event On
function and press ENTER
button another time to test Event Off.
The event must be displayed on the Scheduler-Timer screen to run the
tests and a Device ID must be valid and stored for the specific event.
(8 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais